Power On

The AVB Tool has a standby switch at the front.

Perform the following steps to power on the AVB Tool:

  1. Ensure that the power inlet is properly connected to a power source.

  2. The power indicator will light up in red (Standby) or white (On). This depends on the state of the device before it was disconnected from a power source.

  3. If the device is in standby mode, hold the encoder for two seconds to boot the device.

The AVB Tool features a dark mode which deactivates some or all lights of the front panel. This can be used to let the device appear powered off when it is in fact powered on. A short push on the encoder or any button deactivates this mode temporarily.