Firmware Revision History

Fix: Under rare circumstances, booting the device would take unusually long with 3.0.6

Avnu™ MILAN® Certified

Feature: Allow manual selection of anti-aliasing filter

Feature: (MIDI) Improved response to parameter change request messages

Feature: Faster change of sampling rate

Fix: Warnings were shown for inactive routings at high sampling rates

Feature: (Redundancy) Reflect synchronization to secondary AVB stream in Clock state

Fix: 0 dBFS signals immediately following a clipped signal would continue to indicate OVR

Feature: Improved user guidance after change of sampling rate while streaming

Feature: Faster preset name changes

Feature (WebUI/GUI): Better visualization of peak levels when peak levels are activated

Feature (WebUI): Improved appearance of truncated labels

Feature (WebUI): Change device name using the web interface

Feature (WebUI): Show miniature level meters while in routing mode

Fix (WebUI): Firmware update will proceed even if browser connection is lost

Fix (WebUI): Prevent context menus while dragging or when right-clicking

Feature (GUI): Network configuration (IP address) can be performed at the device

Feature (GUI): New Identify Screen

Fix: Switch off ethernet port LEDs on startup

fixed: ATDECC: Closing a controller stopped notifications to other controllers on the network

fixed: AVB Redundancy: Destination MAC address was not set correctly while other port active

Initial Release