Routing Signals to the Outputs

Each output channel of the 12Mic-D can receive any input signal. If preset 1 has not been modified, it contains a routing of all analog inputs to all digital outputs. However, this can be adjusted and changed easily. The factory default preset does not contain any routing.

A routing immediately activates input monitoring for a corresponding digital input and raises a warning in the input state if the source signal is not available or out of sync.

The following example shows the procedure to route to MADI Coaxial output channels. Other outputs follow the same procedure.

To create a routing to a MADI Coaxial output:

  1. Open the routing tab of the MADI Coaxial output in the OUTPUT section (see Controlling the device).

    Coaxial Output

  2. Activate the routing destination and choose an output channel with the encoder (steps 1 and 2).

  3. Activate the routing source and choose an input channel with the encoder (steps 3 and 4).

To remove a routing:

  1. Navigate to the corresponding output channel (1, 2).

  2. Double click on "Increment routing". The routing source will be changed to "not routed".

  3. (optional) Hold "increment routing" while turning the encoder to remove routings to the following output channels.

To route consecutive channels:

  1. Navigate to the first output channel (1, 2) and create a routing as described above.

  2. Hold "increment routing" while turning the encoder clockwise to increment input channel and output channel at the same time.