Quick Start (MADI)

Follow this procedure to get running quickly!

  1. Load Preset 16 (Factory settings) from the STATE section

    Presets

  2. In the CLOCK section, choose a sample rate and verify that the device is set to internal clock reference or that the chosen clock source is in sync.

    Clock Master

  3. After connecting an analog signal, adjust its reference level as needed in the INPUT section

    Analog input settings

  4. Open the tab of the preferred digital output in the OUTPUT section and choose "Analog 1-16" as source.

    Analog input settings

  5. Set the preferred reference level in the analog configuration tab of the OUTPUT section

    Analog output configuration

  6. Choose a digital input source for the analog outputs in the OUTPUT section

    Analog output routing

done!

Further steps to enhance your start:

State
Input
Output